Blog
What should I do if a pipe bursts in my house?
After a burst pipe, go to your water meter, usually in a small box near the front boundary, and turn the valve beside it off: most have a small bar that turns a quarter turn. Then switch off electric hot water at the switchboard, open a low cold tap and call a licensed plumber.
Step 1: Find your water meter
On most Brisbane houses the meter sits in a small plastic or concrete box near the front boundary, often beside the footpath, driveway or front fence. In townhouses and units, meters are often grouped in a services cupboard, a meter room or along the driveway. If you have never found yours, read Where is my water meter? before you need it.
Step 2: Turn the valve off
The valve beside the meter controls the supply to the property. Most have a small bar across the centre that turns a quarter turn (90 degrees); older tap-style valves turn clockwise until they stop. Turn it by hand, then open a tap inside to check the water has stopped. Do not force a stiff valve: older valves can corrode and snap, which makes the leak worse.
Step 3: Make the hot water system safe
If the water will be off for more than a short time, switch off an electric hot water system at the switchboard. Turn a gas system to pilot or off, following the instructions on the unit.
Step 4: Drain the pipes
Open a cold tap at the lowest point of the property, such as a garden tap. This lets the water left in the pipes drain out there, not through the burst.
Step 5: Record the damage and call a licensed plumber
Take photos of the burst and any damage for your insurer, then call a licensed plumber.
Only one fixture leaking? Use the isolation valve
Toilets, basins and kitchen sinks usually have a small isolation valve on the supply pipe underneath. Turn it clockwise to stop water to that fixture while the rest of the house keeps running.
Queensland requirement vs our recommendation
- Queensland requirement: repairing or replacing pipes is regulated plumbing work and must be done by a licensed plumber (QBCC). Turning off your water while you wait is fine.
- Our recommendation: find your meter now, keep the lid clear, turn the valve off and on every so often so it doesn't seize, and make sure everyone in the house knows how to use it. If it is seized, leaking or missing, have a plumber replace it before an emergency.
FAQs
Which way do I turn the water meter valve to turn off my water?
Most meter valves have a small bar that turns a quarter turn (90 degrees); older tap-style valves turn clockwise until they stop. Turn it by hand, then open a tap inside to check the water has stopped.
What should I do if the valve at my water meter won't turn?
Don't force it or use tools, as an old valve can snap and make the leak worse. Call a licensed plumber. If water is leaking at the meter itself, call your water provider (Urban Utilities faults and emergencies: 13 23 64).
Should I turn off my hot water system after a burst pipe?
If the water will be off for more than a short time, yes. Switch off electric systems at the switchboard and turn gas systems to pilot or off, following the instructions on the unit.
Can I repair a burst pipe myself in Queensland?
No. Repairing pipes is regulated plumbing work in Queensland and must be done by a licensed plumber. You can turn off the water and photograph the damage while you wait.
What is an isolation valve?
A small valve on the supply pipe to a single fixture, such as a toilet, basin or sink. Turning it clockwise stops water to that fixture while the rest of the house keeps running.
Related
Pipe burst? Turn off the water, then call PlumbCore Australia on 1300 165 358. Our phones are answered 24/7 and there's no call-out fee in business hours. Find us at plumbcore.com.au.
